Cleanup After Using a Fire Extinguisher

Having a fire extinguisher in your business or home can help keep a tiny flame from becoming a massive fire. If you’ve had to use one recently, you’ve got to clean up the fire extinguisher residue, not to mention call for a fire extinguisher refill in Longview, TX. Fire safety equipment can be a lifesaver, and you’ll want to make sure it’s refilled and ready after using it. There are some specific steps you should follow, depending on the extinguisher type, to make sure everything is taken care of.

Dry chemical fire extinguisher residue

Dry chemical fire extinguishers leave behind a corrosive powder that can damage whatever it rests on. These need to be cleaned up quickly, especially when used near or on metal surfaces. Vacuum or sweep up any loose debris. Then spray stuck-on residue with an isopropyl alcohol diluted 50 percent with warm water. Let it sit for a few minutes, then wipe with a damp rag. You’ll want to check your fire safety equipment in Longview, TX for the specific type of chemical and follow the instructions on how to neutralize that residue. Afterwards, give a final wash with soap and water, then rinse clean.

Class K wet chemical fire extinguisher

This type of extinguisher is the recommended fire safety equipment in Longview, TX for commercial kitchens. Oil and grease fires aren’t put out by water, so this extinguisher uses a fine mist to cool the cooking surfaces and extinguish the flames. Before starting to cook again, you’ll need to clean up the residue. You do this by turning off the power to all cooking equipment and putting on rubber gloves. Then, using a sponge or cloth dipped in hot, soapy water, wipe away the foamy residue. Rinse clean and allow everything to dry completely before turning the power back on and resuming your normal kitchen operations.

Halotron fire extinguisher

These are older fire extinguishers that are no longer in production, but they are still in use. While they leave behind no visible stains or residue, you still need to clean the location you sprayed. This will remove smoky smells and neutralize the surface area of any leftover agent. First apply a diluted degreaser to the affected area. Then use a sponge for small spots or a spray bottle for larger surface areas. Finally, apply a neutral cleaner to remove any remaining residue and wipe away all cleaning products and let the surface dry.

Anchor Safety Inc. is a premier source for fire safety equipment in Longview, TX. We specialize in providing expert consultation as well as service, sales and installation of all fire protection systems for homes, offices, restaurants, computer server rooms and document rooms. We’ve been in business since 1990 and have more than 50 years of combined industry experience under our belts. You can trust our expertise when it comes to fire safety equipment. Give us a call for a free estimate or to arrange a consultation. We look forward to setting you up with the correct fire safety equipment for your needs!

Categorised in: Fire Extinguisher Refill, Fire Safety Equipment

This post was written by Writer